Technical & Reference Section > Tech and Restoration
SHIMANO DX Spindles............
Discostu:
http://sheldonbrown.com/harris/pedals.html
I'm not sure if these were the ones I found before. :daumenhoch:
As you can see they ain't cheap.
GavinDavis:
--- Quote from: dannywhac on December 08, 2012, 06:57 PM ---
--- Quote from: gavindavis on December 08, 2012, 06:20 PM ---
--- Quote from: discostu on December 08, 2012, 05:40 PM ---Buy the black halfords pedals that are in the dx style. They are around £13 and are a straight swap. :daumenhoch:
--- End quote ---
Bit of a long shot but I dont suppose this trick would work for Peregrine platforms would it Stu? I was thinking of making some you see :daumenhoch:
--- End quote ---
For Perry's they'll work - you do need to trim off (with a Dremel) the last three threads on the new axles to get them to fit though. Done it a load of times :)
--- End quote ---
Nice one Dan :) .....Look to be a cheaper alternative then to making a new set :)
Ed, if your reading.... ;) :daumenhoch:
GavinDavis:
--- Quote from: discostu on December 08, 2012, 06:58 PM ---http://sheldonbrown.com/harris/pedals.html
I'm not sure if these were the ones I found before. :daumenhoch:
As you can see they ain't cheap.
--- End quote ---
Ah cheers for the link Stu :)
It looks as though the final thread is 1/2" to fit an OPC....ultimately allowing you to use a 9/16th on an OPC.....really nice idea if they'd done it the other way round, although i guess it would extend the pedals from the crank arms quite a bit by the look of it.
adenough:
:-\ :-\
http://www.ebay.co.uk/itm/JIC-female-Swivel-x-Bsp-male-Adaptor-9-16-18-x-1-2-6-/160919416197?pt=LH_DefaultDomain_3&hash=item25778b6d85
adenough:
lots of thread tape :LolLolLolLol:
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version