BMX General > BMX Chat

GT rear brake mounting

(1/4) > >>

HUTCHMAN:
Your thoughts please...i got a rather nice ali GT box stay frame circa 1998. The only brake the frame will take is a caliper,but the hole for the caliper spindle is about 8mm(being lazy,measured it with litluns plastic ruler)...am i looking at knocking up a small shim or an alternative rear caliper? was it ACS that made a larger spindle caliper?

Betty:
ACS boa has a large spindle, your frame might have been drilled for one

Easier to find with the larger spindle  :daumenhoch:

HUTCHMAN:
not been drilled..the frame is NOS.

oldtired:
no v brake/ canti mounts ?  

HUTCHMAN:

--- Quote from: oldtired on December 22, 2012, 01:32 AM ---no v brake/ canti mounts ?  

--- End quote ---


no,just a brake bridge.

Navigation

[0] Message Index

[#] Next page