Technical & Reference Section > Tech and Restoration

Oven pride on chainring

<< < (2/3) > >>

CustardLips:
Yes, would like to see some results.  :daumenhoch:

Glynnyboy:

--- Quote from: BENDYCAT ELEVENTEEN on January 01, 2013, 05:43 PM ---pictures people, pictures  :knuppel2:

--- End quote ---
Got to admit a pic of the quality of the end result wouldn't go a miss .
It sounds like a good tip.

Bamb:
Did this one in the summer  , been rode a lot since doing it ,if you look there is a step in the machining which helps guide the brush



On closer image you can see some I've missed near chain

GavinDavis:
Thats turned out awesome! Good job there! Did you mask off the bits you needed to or just got for it?

Bamb:
To be honest I just went for it as I'm terrible at masking curves and I thought tape might suck the oven pride in!!  I had nothing to loose as they look awful  with anodising  half worn off by the chain  :)

Navigation

[0] Message Index

[#] Next page

[*] Previous page