BMX General > BMX Chat

skyway 24

<< < (4/5) > >>

Gary72:
Lovely, but how long is that fork steerer tube :angel:

dordymush:
nice to see you back building old chap.
been ageeeeeeeeeeeeeeees  ;D.
cool machione for sure.
not sure about the spacers on the forks. but deffo one of the nicest iv'e seen of these.

Munnyella:
Lovely

Difficult with a thin stem, would you want to cut the steerer down on a frameset you've waited 14 1/2 years for???

I'd probably not want to, but i'd want that stem....

Run a spinner!!!

Its the only logical solution......... (i've had 8 pints...)

MM

Dark Diggler:
Bob on  :coolsmiley:

hunterdubber:
Matt ,, that is probably the best T/A  24 so far  :smitten:

I saw these gorgeous wheels being built in Diggler's ,,,and when I saw them I knew the rest of the bike was going to be impressive  :4_17_5:

This build has some Quality parts and need to be told  , spec list please  :angel:





--- Quote from: munnyella on February 08, 2013, 09:49 PM ---Lovely

Difficult with a thin stem, would you want to cut the steerer down on a frameset you've waited 14 1/2 years for???

I'd probably not want to, but i'd want that stem....

Run a spinner!!!

Its the only logical solution......... (i've had 8 pints...)

MM

--- End quote ---


No  need Mark ,  :daumenhoch:

 If you want to run the stem in a lower position ,,


 fit one thin spacer,,

 then the stem ,

 and the rest of  spacers go on top,, no need to cut the headtube  :daumenhoch:


 and you could possibly fit this stem in an inverted position ,it would ride right ,but it's not an inverted cruiser stem  ???   :daumenhoch:

Navigation

[0] Message Index

[#] Next page

[*] Previous page