Technical & Reference Section > Tech and Restoration

Peregrine HP-48s hub repairs

(1/4) > >>

Kaner:
Gents

I have a very unhappy rear HP-48s hub, the axle hardly turns.

Is there a rebuild kit available including axel?

Anyone done this successfully before, what might trip me up when doing it?

Thanks

harris:
are you hubs sealed or loose ball,both are easy to replace,pop the bearings out and get the number off the seal
grab some off ebay or your local bearing supplier.

kev-s:
as dan said pop the bearings out and get the number off the seal or just take the whole bearing to a local bearing supplier and they will measure it and give you some the same

as for the axle, it most likely is ok but if not then axles do pop up now and again

Kaner:
Cool, thanks Dan, I will take a look for the number, I've seen loads of bearings on eBay.

It's actually for your old Dirt Bros, beauty of a bike!

ED209:
sorry to jump in on this thread but anyone know where I can get a replacement front axle for a pere super pro hub?

Navigation

[0] Message Index

[#] Next page