Technical & Reference Section > Tech and Restoration

Potts Mod - MX1000

<< < (3/5) > >>

Jaan:

--- Quote from: Devilock on March 09, 2013, 06:32 PM ---Thanks for confirming that Dave...& Chris Ill have you at 3.30 after school!

--- End quote ---

For a blowie?  :-*

sawzall:
first centre punch rivet

then use a 3mm drill bit for a pilot hole then use a larger drill to remove rivet,as far as i can remember 6mm

or if you want pop it in the post and i will do it for you ;)

Devilock:

--- Quote from: sawzall on March 09, 2013, 08:29 PM ---

or if you want pop it in the post and i will do it for you ;)

--- End quote ---

Sounds good to me Phil!! :D

GavinDavis:
Dont be frightened Rich......get yourself a power tool  :daumenhoch:

glenboy:
yep rich did it on the gaystar above and although doesn't look perfect , you can put it back to normal as its only screwed in different , the only thing i needed was the dome washer (improvised) on the cable holder on the caliper , and the brake worked perfect

Navigation

[0] Message Index

[#] Next page

[*] Previous page