Technical & Reference Section > Tech and Restoration
Un-doing an Epoch (GT) headset ..... (Removed)... Thanks .
Hiro Tonka:
dib dobs if it a freestyle version ::)
Andy68:
--- Quote from: nickswan1 on April 04, 2013, 05:32 PM ---
--- Quote from: Andy68 on April 04, 2013, 05:25 PM ---x2....... just ping it out of it's recess with a little flat screw driver, get rough with it!!! :daumenhoch:
--- End quote ---
Shut it Hippie, I answered first! :-*
--- End quote ---
Your answer was just too vague!!! :Aresehole:
So is there rocket science involved re fitting?? Should there be a correct tension? Never had any problems with them but I just slide it down in the fork recess, twirl the fooker round and slot the other end wherever it'll go! Ingenious idea! :)
That Swan Guy:
--- Quote from: Andy68 on April 04, 2013, 07:31 PM ---
--- Quote from: nickswan1 on April 04, 2013, 05:32 PM ---
--- Quote from: Andy68 on April 04, 2013, 05:25 PM ---x2....... just ping it out of it's recess with a little flat screw driver, get rough with it!!! :daumenhoch:
--- End quote ---
Shut it Hippie, I answered first! :-*
--- End quote ---
Your answer was just too vague!!! :Aresehole:
So is there rocket science involved re fitting?? Should there be a correct tension? Never had any problems with them but I just slide it down in the fork recess, twirl the fooker round and slot the other end wherever it'll go! Ingenious idea! :)
--- End quote ---
Oh dear!
:-X
Andy68:
Again, not much of an answer!!!!!! :LolLolLolLol:
Navigation
[0] Message Index
[*] Previous page
Go to full version