Technical & Reference Section > Tech and Restoration
Crown race fitting tool - £3 from B&Q!!
Andy68:
Mr Swan needs one of these after throwing his dummy out the pram on Monday night!!!!! :LolLolLolLol:
Good idea bud...... :daumenhoch:
renegaderacer:
Nice one! :daumenhoch:
I thought of doing the exact same thing a while a go but I didn't know if it would fit.
What diameter tubing is it?
Devilock:
Bargain... So will you be using the fork as the other table leg?
not johndub71:
Spot on that. We had a bitd tool what resembled to video head drums that slid down, but, that looks a lot better. Good find. Now, if you can mod it to fit frame cups too, then your one a winner.
Jaan:
--- Quote from: renegaderacer on April 11, 2013, 09:12 AM ---Nice one! :daumenhoch:
I thought of doing the exact same thing a while a go but I didn't know if it would fit.
What diameter tubing is it?
--- End quote ---
32mm diameter. I bought the 300mm leg but theres 100, 200mm etc. Seeing as most forks measure c.150-160mm the 200mm would be your best bet :daumenhoch:
http://www.diy.com/nav/fix/hardware/ironmongery/legs___supports/-specificproducttype-furniture_legs/Rothley-Furniture-Leg-L120XV-Black-H200mm-x-32mm-Dia-9282005'skuId=9291705
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version