Technical & Reference Section > Tech and Restoration

Bent Dropout

(1/2) > >>

region11:
The bottom part of the rear drop out on my Ripper is bent inwards slightly.  Nothing major, but I want to get it re powdered and decided to repair it beforehand.  What is the best way to straighten the dropout?  I'm sure aluminium cant bent back and forth the same way you can steel!  Any advice would be useful.  Cheers

Devilock:
Just tease it back gently with adjustable grips.

MartyC:
As above but with a large adjustable spanner tight on the  bottom dropout  :daumenhoch:

Devilock:

--- Quote from: MartyC on April 25, 2013, 12:44 PM ---As above but with a large adjustable spanner tight on the  bottom dropout  :daumenhoch:

--- End quote ---

Well where else would he grip it ya loon!!  :D

Jaypeg:
Not every gay is successful in life  :LolLolLolLol:

Navigation

[0] Message Index

[#] Next page