Technical & Reference Section > Tech and Restoration

Opinions needed please

(1/2) > >>

oldschoolace:
Hey guys

I'm looking to run one of these on my next build  :daumenhoch:






But think they look a bit pants with standard chainrings  :-\





I want to expose as much of the slots as possible so hoping i can run something 130 bcd like this





Obviously these are designed for the smaller chains but can i run a larger chain on them or is there a bmx alternative to this chainring? :-\

Gnarlyscoots:
???

All old school chain rings will take a standard 1/8 chain unless stated Clint. If you ran a 3/32 ring on the front, you would also need a 3/32 freewheel as the chain slots are too slim.

You can run a 1/8 chain on everything but the 3/32 chain is too thin to run an standard 1/8 freewheels and chainrings  :daumenhoch:

oldschoolace:
Cheers Terry  :daumenhoch:

Was just concerned the 1/8 chain may feel a little slack on a 3/32 ring and have some lateral movement  :-\

dp and Chopper Dude:
Why not put the chainring on the other side like Brett did on this one:

oldschoolace:
I did think of that but all it does is make the non drive side of the bike look pants  :(

Im just fussy about certain detail  :LolLolLolLol:

Navigation

[0] Message Index

[#] Next page