Technical & Reference Section > Tech and Restoration

Pedal Axle Change to 3PC

<< < (4/4)

oldschoolace:
Should be fine for the vast majority of us oldtimers.  ;)

They are chromo after all and a bit of thread lock would add a bit of piece of mind.
Apparently spacing out your pedals by 20mm or so is prefered by some road riders, they do 9/16 to 9/16 spacers with the same design as in the link  :daumenhoch:

GavinDavis:
Im still yet to do my conversion wity my Peregrine pedals.....the adaptors make life a lot easier but similar to Dan, im not sure how much id trust them?

Dannywhac:
As Clint said - they're up to the job on torque and that, but if you're going to take em ramp/jump where you'll land heavy on 'em (and not always in the middle of the pedal) then they will strip  :daumenhoch:

You got sealed or loose ball Perrys Gav? If they're loose ball just send them over to me and I'll convert them gratis  :daumenhoch: I've got a bab load of spare DX/DX-a-like axles for 3-piece here.

GavinDavis:

--- Quote from: Dannywhac on July 27, 2013, 08:41 PM ---As Clint said - they're up to the job on torque and that, but if you're going to take em ramp/jump where you'll land heavy on 'em (and not always in the middle of the pedal) then they will strip  :daumenhoch:

You got sealed or loose ball Perrys Gav? If they're loose ball just send them over to me and I'll convert them gratis  :daumenhoch: I've got a bab load of spare DX/DX-a-like axles for 3-piece here.

--- End quote ---

Handily enough Dan ive got looseball ones  :daumenhoch:

Ah that would be absolutely awesome if youre sure you wouldn't mind doing it bud?  That'd really help me out big time!

Ill send you a pm over in a few mins my good man  :4_17_5:

Navigation

[0] Message Index

[*] Previous page