Technical & Reference Section > Tech and Restoration
stripping shimano pedals
griff:
I'm looking forward to doing mine
does anyone know if Haro Fusion DX spindles/bits would work? Ed has kindly offered to let me have back the pedals I sold him at MK
markyp:
--- Quote from: kev-s on August 31, 2013, 06:21 PM ---really ??? ???
ive done 3 sets including re-shaping, polishing and a full axle replacement (new cups, bearings, washers etc..) and new end caps
didnt take too long (around 1 hour per pedal) and was quite easy
--- End quote ---
took me a whole day to get the paint of mine,it literally came off spec by spec :crazy2:
Dannywhac:
--- Quote from: griff on August 31, 2013, 06:26 PM ---does anyone know if Haro Fusion DX spindles/bits would work?
--- End quote ---
Yeparoonie they do Griff :daumenhoch: From memory you don't have to swap over the bearings/cone nuts etc either.
griff:
thanks Dan :daumenhoch:
need to give mine a good clean & replace a few missing pins that didn't show up in the sale pics ::) but ends aren't too badly scuffed at all - saw in another thread that sawn off bits of rivet can be used as pins so will see if I can get hold of some and have a bash at fixing them
stupid question but were the silver ones painted?
kev-s:
--- Quote from: markyp on August 31, 2013, 07:53 PM ---
--- Quote from: kev-s on August 31, 2013, 06:21 PM ---really ??? ???
ive done 3 sets including re-shaping, polishing and a full axle replacement (new cups, bearings, washers etc..) and new end caps
didnt take too long (around 1 hour per pedal) and was quite easy
--- End quote ---
took me a whole day to get the paint of mine,it literally came off spec by spec :crazy2:
--- End quote ---
take it you used nitromors not synstrip :2funny: :2funny:
griff you can also use the halfords fpd alloy platform pedal (£12.99) axle bearings, bearing cups etc.... all fit the bare dx body :daumenhoch: :daumenhoch:
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version