Technical & Reference Section > Tech and Restoration
ACS Boa 10mm to 6mm spindle swap
chubby:
--- Quote from: ED209 on September 06, 2013, 08:34 PM ---thank you one and all ... off now to tinker :daumenhoch:
--- End quote ---
you done it yet ???
ED209:
Stripped it down.
Stripped the paint off the calipers and gave them a light polish.
Waiting for the new spindle off Costa!
Full photo story to follow.
brakedancer:
I was going to get one with 10mm spindal and drill my forks is that a bad idea....??
GavinDavis:
I would try and do the conversion before you start drilling mate, its pretty final once youve drilled
brakedancer:
is it still possible to run a cable down for potts if i do drill them...
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version