BMX General > BMX Chat

New frame ID Needed (help please)

<< < (3/4) > >>

Jonny too talll:
Ha ha Turbo Macho, sounds like a second rate male stripper. I do like that cycle pro the forks look good in that colour and I will have a look on vintage bmx tonight and try and pm him. I get the feeling that this going to be yet another but very enjoyable hobby

Taipan:
The rear drop outs both have 3 holes but one is curved and the other straight ish so they are not the same frames?

fischflo:
you mean these?

... hard to say from this angle and pic, but i'd say curved.

And i simply refuse to say that Turbo Macho has three holes and is not straight :yahoo_silent: Ha!

fischflo:
i think someone said this one was an 1985 ?



edit: think the full name would be 'Greg Hill Street Legal' ... and pics of em can be found on museum
->f.ex GhostRiderGt's 1984  http://bmxmuseum.com/bikes/cycle_pro/48111/4
->or here on the bay recently    serial# "40211730"  (item# 221267008135)

...just some pics incase yours turns out a Greg, so you get an idea about decals.
Judging from chromey's early Greg Hill frmes might NOT have had own forks, as did also (Tange then tho..?) earlier Turbo Machos

Jonny too talll:
Cheers for that, I think the forks on mine are different to the one you have put a photo up off. They are sloped at the bottom and mine are flat. I will keep looking on the museum and see if I can get anything else off the internerd :)

Navigation

[0] Message Index

[#] Next page

[*] Previous page