Technical & Reference Section > Tech and Restoration

RACE INC RA10 INFO NEEDED PLEASE

<< < (2/4) > >>

bodamus:
Thanks for that Duncan that's great much appreciated. I have contacted them.

Thanks from bodamus :daumenhoch:

duncan:
You're welcome,

About those forks, they're dated circa '81 and I know they came with the RA6 ('Standard' frame, a Junior by today's sizes), but not sure what type came with the RA10.
Race Inc also did leading-edge type forks (look very similar to Landing Gears), it may have been this type - you might want to check if your build has to be absolutely correct.

Plenty Race Inc bars appear on Ebay, but it's a case of trusting the seller, as you'll no doubt know there are still many 'Race Inc-type' straight and v-bar models available new.

The leading-edge forks appear occasionally on Ebay, though they tend to attract quite a few bids.
I'm after an Xcaliber myself, again they appear occasionally on Ebay - I should probably have asked if they would ship to UK as the ones I've seen so far say US only.

For padsets I read that retrobmx might do them.

stuntmaster:
the landing gear type forks are correct for ra10 as i have a set and if you look at the 24 inch raceinc they are the same on them . . the raceinc were also sold as just ff as my mate bough one new bitd

duncan:
From BMX Action April 1982. Not an RA10, but plenty of nice Race Inc products to look at.
Click to see full size:

[img width= height=]http://i87.photobucket.com/albums/k134/redxxvi/bmx/raceincadt.jpg[/img]

billstup:
Nice one, this is me on mine at Rom in 81 I think, RA-8  :daumenhoch:

Navigation

[0] Message Index

[#] Next page

[*] Previous page