BMX General > BMX Chat

What's the best way to remove

(1/2) > >>

Miley:
Sealed (redline) bearings from a bottom bracket?
Thanks
Miles

Munnyella:
knock them out through the spindle hole, using something softer than the bearing cups, I always start with a length of 15mm copper pipe and a lump hammer, if they don't move with that, Ill use a length of hardwood and a mallet, if that wont shift them, 14mm axle and  metal hammer, worry about the marks after!!

MM

Bob_Acid:
That about sums up my experience too although i usually start with the wood. 9 times out of ten though i end up smashing hell out of it with a steel rod.

Betty:
Socket set extension bar and a hammer

pickle:

--- Quote from: Betty on November 17, 2013, 08:47 PM ---Socket set extension bar and a hammer

--- End quote ---

Yep, works every time..........ping!

Navigation

[0] Message Index

[#] Next page