Technical & Reference Section > Tech and Restoration

Removal of sharp lever grips

(1/3) > >>

factory pilot:
Has anybody ever done this successfully ? I've got a black pair I want to remove and use again..is it possible ? how ?
..if not does anyone have a spare pair they don't mind selling ? ;)

cheers Ant :daumenhoch:

brummie:
hair dryer?
warm them up and then a spray of wd40 perhaps

oldschoolace:
Cup full of boiling water, dunk the lever in, leave for 30 seconds and they should pop off a treat  :daumenhoch:

factory pilot:
Top stuff lads :4_17_5:..will try both(not at the same time ;)) :LolLolLolLol:

Picklez:

--- Quote from: oldschoolace on December 30, 2013, 09:51 PM ---Cup full of boiling water, dunk the lever in, leave for 30 seconds and they should pop off a treat  :daumenhoch:

--- End quote ---

+1, was the method I used all the time without fail bitd

Navigation

[0] Message Index

[#] Next page