Technical & Reference Section > Tech and Restoration

Can a complete Wheel be Powder Coated ???

<< < (4/4)

snoopy72:
Sorry to see it damaged Eddie, it's easy to get distracted and forget about something, probably find a rim shaped ring on the block paving tomorrow where you washed it off , a few years back my dad sprayed the inside of the oven with Mr muscle oven cleaner , left it overnight and in the morning was cleaning the parts when he discovered daylight shining through into the back of the oven, after seeing that i've always used a good old fashioned brillo pad to clean my oven  :daumenhoch:
Mr muscle sprayed onto anodised items should remove coloured ano in about 15 minutes if you agitate it with a tooth brush (wear eye protection) and DON'T use your own toothbrush  :teef:   
 Rinse it well with lots of soapy water, hard anodise is a different matter, better off taking it to an anodisers and getting them to remove it for you.

eddie kidd:

--- Quote from: john4130 on January 10, 2014, 05:11 PM ---it may not be as bad as you think, give it a sand down and a polish to see if it,s left it looking peppered with small holes.

--- End quote ---


You could be right John.

I got the dremmel onto it today for 30 mins and it smoothed out a great deal...

It's tomorrow's project...

superbikedan:
Lads, reading through this and seeing the pics maybe you should try the costic hot, I've stripped loads of hubs, pedals rims etc and my trick is have a cold water tub next to the hot costic, what I do is use boiled water, pure it into the tub than add costic, give it a quick stir and place the item in the tub, it will fizz straight away and the anno will come off in seconds,
dip the item in the cold water then repeat again just holding it in the hot costic for a few more seconds and it will come out mint :daumenhoch:

Navigation

[0] Message Index

[*] Previous page