Technical & Reference Section > Tech and Restoration

Hammerite rust remover dip

(1/4) > >>

nitrohopper:
Hey guys I have this hammerite rust remover dip and I have a large fiberglass buck type yjing to put mu frame and forks in can anyone help me do I have to cover all.the holes inside the frame to stop soulution getting in has anyone used this product before help needed please it say it dilutes to 10 litre s but the bucket I have is a lot larger and I cant get bike covered with 10 litres help please lads

Munnyella:
use bottles/jars/bags of water around the frame to displace the good stuff, i.e make it deeper!!

dont cover the holes, it'll be rusty inside too!

MM

oldschoolace:
You didn't spend 20 quid on it did you? ???
Best thing to do is fill plastic bottles full of water and place as many as you can around the frame to consume as much of the spare volume as possible. this should make you ten litres do further but i doubt it will cover the whole fame.
You may have to flip it as one of the chain/seat stays will probably sit out of the liquid  :daumenhoch:

oldschoolace:
In fact now i look at it again, fook that tub off as you are going to need 10 gallons by the look of it, and buy a cheapo 1 meter diameter paddling pool. Inflate and squash to the frames shape. Jobs a good'un :daumenhoch:

BMX1973:
I always give frames a Oxy acid bath.

Is that Hammerite stuff better ?

Navigation

[0] Message Index

[#] Next page