Technical & Reference Section > Tech and Restoration

Radially spoke length question?

<< < (2/4) > >>

NORTY40:

--- Quote from: hokuspokus74 on March 01, 2014, 10:22 PM ---ok i will go and see if i can find them in the mess out there  "wantit" fook were you get spokes that small,no point me asking halfords,as there as much use as an ashtray on a motorbike :LolLolLolLol:

--- End quote ---

A mate of mine cuts spokes to any size you want mate  ;)

See here :   http://www.radbmx.co.uk/forum/index.php/topic,170045.msg1720323.html#msg1720323

 :daumenhoch:

hokuspokus74:
right am no good at all this measuring stuff with hubs etc lol diameter is 2 3/4 inches,or more likely i aint done it correct,but if you google ....odyssey pro factor hubs 48h....you guys will know better than me lol

what all coloured spokes does he do,is he expensive norty

NORTY40:

--- Quote from: hokuspokus74 on March 01, 2014, 11:02 PM ---right am no good at all this measuring stuff with hubs etc lol diameter is 2 3/4 inches,or more likely i aint done it correct,but if you google ....odyssey pro factor hubs 48h....you guys will know better than me lol

what all coloured spokes does he do,is he expensive norty

--- End quote ---

My hubs were 36's Graham so the 166's are probably not right for 48 hole hubs .

Prices for his spokes are all on the link mate , just click on it  ;)  He only sells stainless DT Swiss spokes , no colours .

hokuspokus74:
Ok so what size would i need for these large hubs? if you look up them hubs,you might find the size of the flanges coz am no good at all that stuff to do with flanges etc etc thicko here joffy :D

do i pay you to get the spokes?

fischflo:
2 3/4 inch = 69.85 mm .......... (you need to measure from middle to middle of the opposite spoke holes)

with the flange width ...........couldn't find any info on Odyssey Pro Factor hubs on the net  .......NONE AT ALL ! :shocked: :2gunsfiring_v1:

Navigation

[0] Message Index

[#] Next page

[*] Previous page