Technical & Reference Section > Tech and Restoration

Starchem Synstrip - Did not work ?????

(1/3) > >>

BMX1973:
Got hold of some of this but it did'nt work. It removed most of paint but not all :shocked:

Any ideas?

fischflo:
Mark Munny's advice on Synstrip:

--- Quote from: Munnyella on February 08, 2014, 05:46 PM ---
Depending on your paint, it can take anywhere between minutes and days though! it does lose its strength once you have applied it, so keep adding fresh.

MM

--- End quote ---
:daumenhoch:

sawzall:
try industrial rubber gloves and a cource wire wool,

you can also brush it on and cover with a bin liner and leave over night :daumenhoch:

BMX1973:
I'll give this a go  :)


--- Quote from: sawzall on June 12, 2014, 09:49 PM ---try industrial rubber gloves and a cource wire wool,

you can also brush it on and cover with a bin liner and leave over night :daumenhoch:

--- End quote ---

BMX1973:
 :daumenhoch:


--- Quote from: fischflo on June 12, 2014, 09:10 PM ---Mark Munny's advice on Synstrip:

--- Quote from: Munnyella on February 08, 2014, 05:46 PM ---
Depending on your paint, it can take anywhere between minutes and days though! it does lose its strength once you have applied it, so keep adding fresh.

MM

--- End quote ---
:daumenhoch:

--- End quote ---

Navigation

[0] Message Index

[#] Next page