Technical & Reference Section > Tech and Restoration

Pedal axle help required

<< < (2/2)

Gnarlyscoots:

--- Quote from: chubby on July 12, 2014, 11:11 PM ---Thought you'd sold them Terry  :chin:

--- End quote ---
I sold one set and kept the others bro  :daumenhoch:




--- Quote from: chubby on July 12, 2014, 11:15 PM ---Not that helpful but you should use an opc  :daumenhoch:

--- End quote ---
The build deserves something a little bit more special than a OPC and I really really like these pedal  :D

snoopy72:
It's the spline that's the problem , what goes on the spline ?
Could get them made out of titanium but I fell into that trap of expense.
I've seen them in 9/16 i'm sure recently, i'll look out for some a pm you :daumenhoch:, i'm like a pit bull when i'm looking for a part :daumenhoch:

snoopy72:

--- Quote from: snoopy72 on July 13, 2014, 06:07 AM ---It's the spline that's the problem , what goes on the spline ?
Could get them made out of titanium but I fell into that trap of expense.
I've seen them in 9/16 i'm sure recently, i'll look out for some a pm you :daumenhoch:, i'm like a pit bull when i'm looking for a part :daumenhoch:

--- End quote ---
I have looked on the original advertising sheet of ACS and they don't mention anything about 1/2 only, it's a long shot, i have contacted someone in the States that had a set in 9/16 but wanted 1/2, the post is a couple of years old but I have been very lucky in the past.

Navigation

[0] Message Index

[*] Previous page