Technical & Reference Section > Tech and Restoration

Threadless clamp on dilema. Any ideas??

<< < (2/2)

Gary72:

--- Quote from: EDBANGER on July 18, 2014, 07:46 PM ---
--- Quote from: Gary72 on July 18, 2014, 07:42 PM ---If its the right size, I have had too on 1 1/18 stems take the bolts out and wind them in from the wrong side with a penny or a knife in the slot to make the opening slightly bigger. Slide the stem on and them put the bolts in the right way.

--- End quote ---

Tried that one.  Hammered a  hard wooden wedge in to try and spread the gap a bit.

--- End quote ---
Hope you tried it from the bottom. :)
If in doubt, Get the angle grinder out >:D

Navigation

[0] Message Index

[*] Previous page