Technical & Reference Section > Tech and Restoration
83' Robinson 24" Cruiser build
BADDH:
--- Quote from: moza on September 18, 2014, 03:47 PM ---very nice, are you using that size bars ?? I had a nightmare choosing the right size for my 24 :(
--- End quote ---
I haven't decided yet TBH buddy, I have a set of 5.5" on there way to me albeit I have been advised that bitd the guys used the 7" Expert Robbo bars on them as they set up a bit better ? Plus using this stem it's quite low profile in terms of lift compared to other stems...
Time will tell I suppose :(
southern andy:
Nice, i'm liking that. Even more so as it's rare and i looooooooooove rare :smitten:
I built a cruiser this year, it was a hard build as parts are more scarce than 20" stuff. I think i ran 40-16 on it although i'm not 100% sure on that.
:4_17_5:
Jaypeg:
Looking forward to seeing this get built up and curious about the bb kit
moza:
mine are around 7" I tried some CWS normally on a 20" and they felt good but looked wrong
BADDH:
She's nice there mate, what tyres are those and were from ?
I ve seen Justin is doing Comp 3's and a few on the Bay but wondered if these can be sourced locally.
Just been and collected my wheels >:D
and "wantit"
I ve come back with more than I went for AGAIN ... :coolsmiley: all NOS stock cannot be around much longer.. Eyes bigger than belly talk. .. "help"
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version