BMX General > BMX Chat

KOOLKAPS

<< < (2/2)

dp and chopper dude:

--- Quote from: rodriguez on September 26, 2014, 11:36 AM ---There's a couple of people that make them maybe they could do you a bespoke set.

Bear in mind you really need to get covers for the bit of plastic hub that's left exposed too.

--- End quote ---

Theres a bloke on facebook that makes the caps to cover the exposed plastic. I'll see if I can dig out a link to his page.

trebor:
Didn't the originals have the plastic hubs anyway?  i think the only difference is the originals would've been loose ball rather than sealed bearings  ???

meticulous:
make sure you get ones that are specifically for 24in tuffs,  theres a little plastic lip where it meets the gold hub on mine that stops the caps fitting flush,  its only a couple of millimetres but enough for the cap to foul the cog on the rear.... 

Navigation

[0] Message Index

[*] Previous page