Technical & Reference Section > Tech and Restoration
Anyone tell me where to get another of these bolts...?
ED209:
Sir Phil of Sawzall kindly sent me 2 x bolts but they werz too big... the thread is right tho :-)
Will take a pic later so you can see.
Gary72:
Get your grinder out and make them shorter, Put a nut on the bolt first though :daumenhoch:
MartyC:
Hack saw, vice and a file ::)
ED209:
I mean the 'spacing' of the thread is right ... compared to the ones I had ... but the width of the bolt is too big.
Anyway I'll do a pic in a bit ...
MartyC:
--- Quote from: ED209 on October 17, 2014, 12:05 PM ---I mean the 'spacing' of the thread is right ... compared to the ones I had ... but the width of the bolt is too big.
Anyway I'll do a pic in a bit ...
--- End quote ---
:LolLolLolLol: Why didn't you say that? Can you measure the diameter of the bolt heads with a vernier caliper?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version