Technical & Reference Section > Tech and Restoration

hutch stem help!

<< < (2/4) > >>

CustardLips:
Do you mean the angular cut at the bottom of the shaft is sat skew wiff with the top of the stem. ???

Jaan:
I can see what looks like an ellipse shaped gap between the bottom of the quill and the wedge.  If it doesn't affect performance i.e. the stem stays solidly in position then i'd mention something like "the machining at the bottom of the quill isn't quite straight however this doesn't affect installation" and leave it at that.

raddad:


Hopefully this pic tells the story a little clearer. The stem/shaft/wedge are configured slightly to the right of straight....the shaft is firm in the base of the stem.....any ideas....I just wanna sell the bugger!

Jim

hokuspokus74:
I'll give you £5 for the stem if your happy with it no charge to you in the paypal :daumenhoch: :laugh: :crazy2: :D worth a try though

raddad:
I couldn't do it to you, the quality of the chrome is too low..... :D

Navigation

[0] Message Index

[#] Next page

[*] Previous page