Technical & Reference Section > Tech and Restoration

Annodising hubs

(1/2) > >>

CustardLips:
Is it simple or are there any difficulties with the bearing cases being steel... can they just be masked off or do they need popping out ?

stidds:
Basically anything that isn't aluminium will be eaten away by the anodising process.

Remove anything that is steel, or it will not be there when you pick the part up from the anodisers.

NORTY40:

--- Quote from: stidds on December 14, 2014, 12:12 AM ---Basically anything that isn't aluminium will be eaten away by the anodising process.

Remove anything that is steel, or it will not be there when you pick the part up from the anodisers.

--- End quote ---

I always thought that but Paul at CCA did a Suntour stem for me (polished alloy to Red) and he didn't remove the shaft . Maybe it's because the shaft was chrome plated that it doesn't affect it :-\  . There was no damage at all to the chrome plating on the shaft .

Gnarlyscoots:
Speak to Jay, anodiser_chick, on here  :daumenhoch:

Check on here and you will see she has done blue hubs and rims >>  http://www.radbmx.co.uk/forum/index.php/topic,177446.25.html

CustardLips:

--- Quote from: Gnarlyscoots™ on December 14, 2014, 12:28 AM ---Speak to Jay, anodiser_chick, on here  :daumenhoch:

Check on here and you will see she has done blue hubs and rims >>  http://www.radbmx.co.uk/forum/index.php/topic,177446.25.html

--- End quote ---
Yeah that's the plan Terry but she ain't been on for a bit so just asking the question like.  :daumenhoch:

Navigation

[0] Message Index

[#] Next page