Technical & Reference Section > Tech and Restoration

OGK mag sealed bearing conversion

<< < (4/4)

Mikku:
You've got the same problem then? In any case, that was a good read and well worth a thread bump! :daumenhoch:

Chilli Rinse:

--- Quote from: Mikku on May 17, 2023, 11:29 PM ---You've got the same problem then? In any case, that was a good read and well worth a thread bump! :daumenhoch:

--- End quote ---

I will know for sure when I have the mags in my hands, I am expecting this to be the case though. This seems to be a nice little upgrade if you are going to do a rebuild anyway.

I will update you with the plan soon  fistblump

Chilli Rinse:
I didn't need to go through with the upgrade. The races and cones were very clean, I had some new bearings of the same size laying around so I popped them in for good measure. A lot less work and they are spinning sweet now. I just need to sort the spacing out when the time comes to fit them. They look like shit but run like a dream, just what I wanted.

I have bookmarked this thread for future reference, if the need arises.
 fistblump

Navigation

[0] Message Index

[*] Previous page