Technical & Reference Section > Tech and Restoration

Ripper question!!!

(1/4) > >>

hokuspokus74:
I was wondering if any of you guys had removed the pivots at the back off the frame for the brake and added a brake bridge too it instead? if so whats the best way to remove the pivots then did you file or sand it smooth to blend in with the frame,i know id need to take it too an alu welder to make and put the brake bridge on.

cheers graham

Retrodan72:

--- Quote from: hokuspokus74 on January 25, 2015, 12:44 PM ---I was wondering if any of you guys had removed the pivots at the back off the frame for the brake and added a brake bridge too it instead? if so whats the best way to remove the pivots then did you file or sand it smooth to blend in with the frame,i know id need to take it too an alu welder to make and put the brake bridge on.

cheers graham

--- End quote ---

Graham, I'm sure there was some one on here a few years back, that did this to a Quadangle, could have been Darren KAP.

hokuspokus74:
Is he still on here Dan,be good if there a few pics of it :daumenhoch:

Retrodan72:

--- Quote from: hokuspokus74 on January 25, 2015, 04:00 PM ---Is he still on here Dan,be good if there a few pics of it :daumenhoch:

--- End quote ---

He's not been about for 2 years or so now Gray, sorry.

His bikes will be in M&MB still though.   :daumenhoch:

hokuspokus74:
Seen his bikes there Dan,be better if there was someone had done this  type of thing recently to five me some info on it etc :daumenhoch:

Navigation

[0] Message Index

[#] Next page