Technical & Reference Section > Tech and Restoration

Bent seat post

<< < (3/3)

Dannywhac:
Could you not schlep one of them internal plumbers bending springs into it, and do the sandbag/rubber mallet jobby on it Nick?

CustardLips:

--- Quote from: Dannywhac on April 14, 2015, 10:33 AM ---Could you not schlep one of them internal plumbers bending springs into it, and do the sandbag/rubber mallet jobby on it Nick?

--- End quote ---
Don't think I'd get one in Dan... think the bends too close to the top. Might just fit it and see how it looks. If it's noticeable I'll probably go with the rubber mallet/sandbag approach.  :-\

Bigfrawg:
I would be surprised if you could get a plumbers spring up there , tried it with one of mine . Maybe try a sparks conduit spring or sand load it then give it the hammer treatment .
Failing that just buy a new one ya tight fooker  :D

CustardLips:

--- Quote from: Bigfrawg on April 15, 2015, 07:03 AM ---Failing that just buy a new one ya tight fooker  :D

--- End quote ---
:LolLolLolLol: I've just bought this fookin one off the bay of pigs but no mention or pics of the bend.  >:(

Navigation

[0] Message Index

[*] Previous page