Technical & Reference Section > Tech and Restoration

Bullseye 1st gen cranks help!!!

<< < (2/3) > >>

john4130:
are they 2 piece cranks? if they are i would just use the flap wheel as suggested. if they are 3 piece, check the axle on the other side to see if it has a ridge also.

Gnarlyscoots:

--- Quote from: john4130 on April 28, 2015, 05:31 PM ---are they 2 piece cranks? if they are i would just use the flap wheel as suggested. if they are 3 piece, check the axle on the other side to see if it has a ridge also.

--- End quote ---
No, they are 2 piece John. I don't have anything like that kicking around but I do have a file that I will have a go with I think. I just don't want to get it over the 'ridge' and then it slops about on the axle. Even the slightest movement can be felt when peddling.

Bigfrawg:
Smash the coont on with a hammer

Chris123:
Axle in the freezer, heat the spider gently with a fan heater or hair dryer etc.
if it anodised don't get it too hot.

pickle:
does it not have the same ridge at the other end Terry  ???

Navigation

[0] Message Index

[#] Next page

[*] Previous page