Technical & Reference Section > Tech and Restoration

Fitting motorcycle grips with a 1 inch throttle bore?

(1/2) > >>

oldschoolace:
Seen some grips I like but one is 7/8th bite and the other is 1 inch for a throttle.  >:(

Anyone ever fitted these and have any ideas about making up the difference besides using electricians tape?

rodriguez:
Buy two pairs and use the two smaller ones   :daumenhoch:

Retrodan72:

--- Quote from: rodriguez on April 28, 2015, 07:49 PM ---Buy two pairs and use the two smaller ones   :daumenhoch:

--- End quote ---

Just about to suggest the same, of they're not too expensive that is.  :daumenhoch:

oldschoolace:
Did think that and they are fairly reasonable but with postage from the states it makes me think twice  :-\

Gnarlyscoots:
Cut into a strip and wrap an old inner tube around the bar end before putting the grip on Clint  :daumenhoch:

Navigation

[0] Message Index

[#] Next page