Technical & Reference Section > Tech and Restoration

DX resto question

(1/2) > >>

58 delray:
how easy is it to replace the pins on DX pedals and what should i replace them with if it is possible ?

laidback:
I've heard that welding rod is a good replacement...i'm about to restore some of mine. there's caps on ebay at the moment if you need any :daumenhoch:

58 delray:

--- Quote from: laidback on May 26, 2015, 10:23 AM ---I've heard that welding rod is a good replacement...i'm about to restore some of mine. there's caps on ebay at the moment if you need any :daumenhoch:

--- End quote ---

i have caps, its just the studs i need, will look into the welding rod  :daumenhoch:

fischflo:
Some tips here, not looked into it, but might be worth a look - check out Griff's especially the 'dowel pins!' one sounds promising............ http://www.radbmx.co.uk/forum/index.php/topic,169353.0.html ............ :smiley6600:

HUTCHMAN:
ok, one suggestion... i used to work for Stuart Turner pumps many years ago and have a fair knowledge of the stuff they did for their line of model steam engines. Long story short, Stuart Models, now in Bridport, do a range of stainless steel rod.. eg 3/32 , 1/8 and upwards . About £4.50 for a 12 inch rod. feel sure this may be preferable to welding rod ??

http://www.stuartmodels.com/products/fittings--tools---accessories/materials

hope this is of use.

Navigation

[0] Message Index

[#] Next page