BMX General > BMX Chat

Profile crank removal

<< < (2/7) > >>

Dark Diggler:
You could pour boiling water over the crank arm a second or 2 before you give the bolt a whack too :daumenhoch:

CustardLips:

--- Quote from: Dark Diggler on June 07, 2015, 10:34 PM ---You could pour boiling water over the crank arm a second or 2 before you give the bolt a whack too :daumenhoch:

--- End quote ---
Nice one Diggler... I'll give that a go too.   :daumenhoch:

dancetothedrummersbeat:
If all else fails you can borrow mine Nick. I can post it to you

CustardLips:

--- Quote from: dancetothedrummersbeat on June 08, 2015, 10:41 AM ---If all else fails you can borrow mine Nick. I can post it to you

--- End quote ---
Nice one Andy... I'll have another go.  :daumenhoch:
If i'm struggling I'll give you a shout.  ;)

Gary72:

--- Quote from: john4130 on June 07, 2015, 09:00 PM ---take off the bolt on one side then tighten the bolt on the other side, that should get them moving. then do as Pooch suggested, or get the removal tool. just screw it in and smack it with a big hammer.

--- End quote ---
Before you do this take both bolts out and make sure they have been fitted evenly, You could be trying to tighten the bolt and it is already against the axle.

Navigation

[0] Message Index

[#] Next page

[*] Previous page