BMX General > BMX Chat

Freecoaster adjustment

<< < (2/2)

john4130:
when putting it back together make sure the washers and the spring are inside the clutch, the bit attached to the small side of the spring will have a couple of flat edges, this part slides inside the cone on the left in this pic.

this is how it should look before inserting it back into the hub.

once it's slid into the hub, screw the driver back on and then the cone nut.

gary67:
 :daumenhoch:

gary67:
Cheers chaps,all sorted now   8)

john4130:
did you add some washers? if so, is the gap ok now.

Navigation

[0] Message Index

[*] Previous page