Technical & Reference Section > Tech and Restoration

One down... one to go...

(1/2) > >>

beard1973:
My first attemp at lacing... 3 hours later....

dj_benice:
Lookin good, got two sets of 1 3/8 here need lacin to small flange suzue's, if anyone can tell me what spoke size I need might give it a bash myself.  Again nice work beard :)

steve:

--- Quote from: dj_benice on September 01, 2006, 12:46 AM ---Lookin good, got two sets of 1 3/8 here need lacin to small flange suzue's, if anyone can tell me what spoke size I need might give it a bash myself.  Again nice work beard :)

--- End quote ---

220mm - ish

dj_benice:
ta, when you say ish should I err on the side of caution and go slightly longer? or shorter?


cheers steve
peter

steve:


-the peice of a4 =210mm
-its a low susie in a 1.3'8
-if you can get 218mm??? -thats em

Navigation

[0] Message Index

[#] Next page