BMX General > BMX Chat

Tuff neck patten pending

(1/1)

nitrohopper:
Hi guys does anyone know what year did tuff neck stop making this stem cheers in advance

Sent from my D6603 using Tapatalk

Gnarlyscoots:
This will give you an idea to work it out roughly.



A. 1977 to 1978 - No markings, may have had a Tuf Neck sticker on, Square corner.

B. 1979/80 - Tuf-Neck Patent Pending engraved on the cap, Square corner.

C. 1980 - Tuf Neck 2000, Rounded front and back.

D. 1981 - Introduction of the Tiger Head and Tuf Neck USA stamp on the cap.

E. 1981 - Rounded corners with Tiger Head and Tuf-Neck USA stamp (I think was done to prevent further knee injuries).

F. 1982/3 - Rounded corners and Potts Mod bolt. Tiger Head and Tuf-Neck USA stamp on the cap.

G. 1984/5 - Tuf Neck ACE model - Rounded corners and Potts Mod bolt. The stem was made shorter for Freestyle and flatland by adding a cut out in the cap. Tiger Head and Tuf-Neck USA stamp on the cap.

H and I. 1985 to 1987 I believe. Same as previous models, Tiger Head and Tuf-Neck USA silk screened on the cap. Not sure for what purpose though.

nitrohopper:
So would a d cover 84 then

glenboy:
As above came out 1979 and went out of production by 1980

Gnarlyscoots:

--- Quote from: nitrohopper on July 01, 2015, 11:50 PM ---So would a d cover 84 then

--- End quote ---
No buddy. I would say F to I should cover it nicely. It if's stamped Pro Model, that is fine too. Same stem, just stamped Pro Model instead  :daumenhoch:

Navigation

[0] Message Index