Technical & Reference Section > Tech and Restoration

Is this a restore or refinish?

<< < (3/5) > >>

Ady:
cheap as chaps....

http://www.ebay.co.uk/itm/170572693487?_trksid=p2057872.m2749.l2649&ssPageName=STRK%3AMEBIDX%3AIT

BMX1973:
That would come out near minty with a oxy bath :daumenhoch:

Nice DB  :)

sparky:
The box section looks like it might have had a kickstand attached at some point, that or something which has caused the concave. You might also want to check the fork rake because they look a little off-set going by the angle of the headstock tubing.

Old School:


--- Quote from: sparky on September 24, 2015, 06:20 PM ---The box section looks like it might have had a kickstand attached at some point, that or something which has caused the concave. You might also want to check the fork rake because they look a little off-set going by the angle of the headstock tubing.

--- End quote ---

Thanks guys, ace advice as always!
Mark, how do you mean the forks are offset and what am I looking for?
Sorry if it's obvious!

Couple of other questions:
How do I remove the decals?
Does anyone on here do repop decals?

Cheers :daumenhoch:


Sent from my iPhone using Tapatalk

hokuspokus74:
Old school use a heatgun or hair dryer to remove the decals,then if there is sticky residue after you remove them spray wd40 on it and use a white scourer pad as it wont scratch the F&F DONT USE GREEN, on the resto stickys you will see where it says dels new website or something hes the main man for decals top class job ;)

Navigation

[0] Message Index

[#] Next page

[*] Previous page