Technical & Reference Section > Tech and Restoration

Spoke sizes no need for calculations

<< < (3/3)

Steve P:

--- Quote from: martyC on September 04, 2006, 10:31 PM ---I'm not so sure Steve, I've had a look in the museum and there looks to be a lot of large flanges with your name on them

--- End quote ---

Okay, I confess . . . I don't mind a large flange once in a while . . . gotta have a good seal though  ;D  ;D

MartyC:

--- Quote from: Minihaha on September 04, 2006, 10:35 PM ---
--- Quote from: martyC on September 04, 2006, 10:31 PM ---I'm not so sure Steve, I've had a look in the museum and there looks to be a lot of large flanges with your name on them

--- End quote ---

Okay, I confess . . . I don't mind a large flange once in a while . . . gotta have a good seal though  ;D  ;D

--- End quote ---

So what you're saying is a large flange is OK so long its a tight fit?  :LolLolLolLol:

dj_benice:
perverts the lot of you what has happened to this thread  :2funny:  :2funny:  :2funny:  :2funny:  :2funny:  :2funny:  :2funny:  :2funny:  :2funny:  :2funny:  :2funny:  :2funny:  :2funny:

Steve P:

--- Quote from: martyC on September 04, 2006, 10:38 PM ---So what you're saying is a large flange is OK so long its a tight fit?

--- End quote ---

Not found one yet Marty but still looking . . . NOS or ex-show :2funny:

Right, back to the spokes then . . . . . !!!

theRuler:
any flange will do

Navigation

[0] Message Index

[*] Previous page