Technical & Reference Section > Tech and Restoration

ALLY HUB TUFF REBUILD....

(1/2) > >>

deeman:
I am rebuilding my front ally hubbed Tuff ....I was wondering how to get the old bearing cups out? I tried a screwdriver and a whack like a bb cup and it did not move but I didn't want to go too mad in case I damaged the hub. Am I tackling it right or is there another way of going about it? any help appreciated...
Damo  :daumenhoch:

oldschoolace:
Pretty sure you just knock them out Damo. Just make sure you have the wheel hub well supported. I dont think its a job that can be done with any reall finesse

deeman:

--- Quote from: oldschoolace on January 20, 2016, 04:18 PM ---Pretty sure you just knock them out Damo. Just make sure you have the wheel hub well supported. I dont think its a job that can be done with any reall finesse

--- End quote ---

 :LolLolLolLol:
Thanks Clint, I will stop touching it up and fooking whack it then!  :daumenhoch:

oldschoolace:
You could carefully take a Dremel cutter to it if you get stuck but it should pop out ( with a big whack!)
make sure you work your way round so it comes out square  :daumenhoch:

58 delray:
the raised portion of the outside of the hub needs to be placed on something like suitably sized socket or a vice opened to the correct size so that when you knock the cup out you dont push the hub flange out as well

Navigation

[0] Message Index

[#] Next page