Technical & Reference Section > Tech and Restoration

Can any one recommend the right bars for a ripper build with flo panel

(1/2) > >>

threaders:
Hi.
Just getting the parts together for an early 80s ripper :) just need the bars and wanted to fit a flo panel on them too.

Can anyone recommend a set of bars between £50 and £70 ish and will the flo panel fit ? Or do I need a different plate? Also the tech numbers I have are to large and are fitted with pegs. Anyone know the right numbers I need? I did want black numbers with a white outline. Many thanks fellas :daumenhoch:

Ady:
GT SANTA ANA PRO BARS J...
But they are $$$$$$$
There are copies out there..
Or renthal bars bud..
Or Hutch ladder bars.. ::) ::)

CustardLips:
You need a set of SE Powerwings for a Ripper.  :daumenhoch:
I doubt you'll find some for that sort of money though unless they're a bit battered.  :-\

threaders:
Cheers fellas :) seen some gt Santa Ana bars for £299 :shocked: and some power wings on eBay, but I don't think they are old school though. Am I looking for 29" wide and 8" rise or thereabouts? Do you think the flo panel will work or is there another plate that would work better? Thanks for the info

kungfunky:
The Neal Protoplate is the best fit for Powerwings. And as for the bars you'll pay £130-£220 depending on condition.

Navigation

[0] Message Index

[#] Next page