Technical & Reference Section > Tech and Restoration

Help my brothers , how do you remove the shaft from a tuf neck /pro

<< < (3/3)

oldschoolace:
I've removed shafts from interference fitted stems before, question is why do you need to?

jonnydiezel:
was thinking if it was possible have a silver one annodised to blue?
but understood that with the steel shaft attached it probably wouldn't work

oldschoolace:
I imagine there would be a way to annodise it with the shaft in. You can't anno steel so it may just be a case of doing the lot. Either that or some sort of masking fluid/tape

rodriguez:

--- Quote from: oldschoolace on April 24, 2016, 11:04 PM ---I imagine there would be a way to annodise it with the shaft in. You can't anno steel so it may just be a case of doing the lot. Either that or some sort of masking fluid/tape

--- End quote ---

This can and has been done by CCA and Chameleon successfully who masked off the the shaft using tape.

Will make an awful mess of the shaft if it's not done properly though, seen one that hadn't been done properly and the shaft was corroded to fook.

Navigation

[0] Message Index

[*] Previous page