Technical & Reference Section > Tech and Restoration

AD990 set up help

<< < (2/4) > >>

Lpodonovan:

--- Quote from: pickle on September 08, 2016, 08:53 PM ---What frame is it?

--- End quote ---
1995 S&M Dirtbike

Lpodonovan:
Inner cable hitting frame hole (sitting too low in hole IMO)

Lpodonovan:
Short barrel adjuster (probably sitting half way through tube (not sure if this should be longer and pop out otherside?)

Lpodonovan:
Difficult to see but these arms are touching each other and are slightly rubbing when pulling brake lever

Andyboy77:

--- Quote from: Lpodonovan on September 09, 2016, 09:31 AM ---Difficult to see but these arms are touching each other and are slightly rubbing when pulling brake lever

--- End quote ---

In this case I would try a suitable washer at the upper arm to  lift it just enough to get rid of the rubbing isssue.  :daumenhoch:
Regarding the other issue, I don't know about any adjusters that long so that it would go through the frame tube. But that doesn't mean they don't exist. Can you fit a piece of an outer cable there to prevent it from rubbing agianst the frame?

Navigation

[0] Message Index

[#] Next page

[*] Previous page