Technical & Reference Section > Tech and Restoration

Haro bars

<< < (2/2)

griff:
I thought 85 ones were a bit taller?

factory pilot:

--- Quote from: griff on February 18, 2017, 07:26 PM ---I thought 85 ones were a bit taller?

--- End quote ---

The very early ( 1st Gen ) were wider and taller and stamped Anlun ( these are the most rare - I've got them on my early 85 master ) but production was very erratic after that.

kalex:
I had a late 85 and that had smaller diameter tubing with a larger diameter just on the stem clamp area and it was knurled. I think they only did them for 1 year only like that

griff:

--- Quote from: factory pilot on February 18, 2017, 07:30 PM ---
--- Quote from: griff on February 18, 2017, 07:26 PM ---I thought 85 ones were a bit taller?

--- End quote ---

The very early ( 1st Gen ) were wider and taller and stamped Anlun ( these are the most rare - I've got them on my early 85 master ) but production was very erratic after that.

--- End quote ---

The ones I had on my 85 master were (I think) from 87
Not Anlun made though, I forget the make but there's a thread possibly still on here somewhere
They were lower rise then the ones you're on about anyway

griff:
Found the thread - they were made by Leadtec

Navigation

[0] Message Index

[*] Previous page