BMX General > BMX Chat
Mx1000s can you powdercoat after stripped
tfi_friday:
--- Quote from: rodriguez on April 15, 2017, 05:33 PM ---
--- Quote from: tfi_friday on April 14, 2017, 03:06 PM ---
--- Quote from: rodriguez on April 14, 2017, 02:38 PM ---powdercoating is too thick and not really worth the effort IMO, spray bomb if you must :daumenhoch:
--- End quote ---
It's possible to have them reanodized with the.plastic washers in situ.
--- End quote ---
even better :daumenhoch:
--- End quote ---
Had this all redone, one lever was NOS and used for colour matching, but the other lever was done intact just needed the extra anodising off the pin removed (10 min job). For the rest the mx1000 Quick release and seat clamp pin needed removed and reinstalled.
Navigation
[0] Message Index
[*] Previous page
Go to full version