Technical & Reference Section > Tech and Restoration

Chubbys meat mallet stem project

(1/7) > >>

oldschoolace:
Its been a while since i have made owt and with the workshop finally dry after the biblical flood i thought it was time i got round to honouring a promise to Rich for something a little different for his next build.


Started with the usual big block of ali with holes drilled for the stem shaft and bars  :)






In my wisdom i decided a stem cap that bolted on from the rear might be fun and wouldnt interupt the desired meat mallet look at the front  :daumenhoch:

half a day drilling 4 very long and neat holes and running the stem nervously through my woodwork router resulted in this.





I decided the other end needed a wide axe/wedge/bone crushing look to it. This also had the nice effect of revealing the long bolt holes  :)









Just need to cut through the bar section, fit a post and give it a final finish and iits all done  :)

griff:
That's ace  :4_17_5:
Wasted on Rich though as he's a vegetarian

Andyboy77:
This is such a cool project Clint! I can't wait seeing it fitted to Richs bike  :daumenhoch:

Jaymz:
Top job Clint  fistblump

chubby:
Feel like I need to put it on something better now  :(

Navigation

[0] Message Index

[#] Next page