Technical & Reference Section > Tech and Restoration

Opinions needed please chaps **Boa upgrade kit in the pipeline**

<< < (4/7) > >>

oldschoolace:
Found one of the black plastic Weinmann spring clamps in my kit box but not been able to find any replacement ones. Suspect the plastic aint up to the job too so had no choice but to make my own.

Made a little clamping jig out of some scrap Ali to keep my bell ringers away from the saw and pretty pleased with the results  :)

griff:
Great work Clint

If you run out of ideas you can borrow my 6-10mm conversion kit :teef:

oldschoolace:
Almost there with it. Just need to shave a little off the spring clamp and its ready to test  :daumenhoch:

CustardLips:
Nice work Clint... could do with one of these when you've got em boxed off.  ;)

chubby:
The rise of mid prices has made people reluctant to drill forks out these days. 6mm kits are near impossible to find & fiddly to swap over. Best thing about this kit is you don't need to mod the arms for the bearings, this means any dickhead can manage to install it & ride  :daumenhoch:

Navigation

[0] Message Index

[#] Next page

[*] Previous page