Technical & Reference Section > Tech and Restoration

Powder coat v Starchems

(1/2) > >>

kalex:
I'm fairly sure starchems can and has been used to good effect on removing powder coating but before I slap it all over I would like some confirmation please

Nigel:
Its as good as nitromorse but I would give it a good scrape with a Stanley blade first
I use Bartoline TX10  just as good an cheaper

chubby:
Sbd uses starchem

Sent from my G8341 using Tapatalk

Cherrypicker:
I’ve used nitromors on the RL20 I’m doing with only partial success after several treatments. Found some organic environmentally safe stuff which took a little more off. Then I went for TX10 which has removed most but not all the paint, again after several treatments. Anybody used the Aircraft Remover? Watched demos of it online, appears to just rip it off in minutes?? Struggling to get paint from the welds.

chubby:
I use a brass wire brush in the awkward areas, doesn't scratch the metal..

Sent from my G8341 using Tapatalk

Navigation

[0] Message Index

[#] Next page