BMX General > BMX Chat

Help fitting an Haro disc to opc

(1/2) > >>

Keepad:
Hi,
 Could I have a bit of help please, so I took my Haro sport to the local bike shop for a service and parts fitted, the only issue they had was fitting my Haro uni disc on a Sugino opc, they said I would need a non threaded 24mm internal size washer to sit in between the right hand side bearing locking nut and the disc- I’ve not heard of this before is that correct- pic included showing bb locking nut and gap to disc.

Any help and pee taking welcome or washers

Keepad:
Another pic to be clearer

Ady:
In the first pic is that the furthest it goes fully tightened ?
The locking nut looks deep enough to clear that gap.
Try it without this spacer they advised, it might mark the disc slightly when tightening, but you normally expect that anyway.
Is it this type of bottom bracket ?
It should really fit..

[ Attachment: You are not allowed to view attachments ]
 

Ady:
Same principle for loose ball or above bearings..

Keepad:
Hi,

It’s a Tange sealed BB,the nut  clears the Gap but shop said when they fitted it they had Still had a gap, I can only assume once the bearing sat inside the cap and the nut was tightened they had a gap in the between the nut and disc, I might make an cap press and have ago myself.

Navigation

[0] Message Index

[#] Next page